• cqtechasol
  

  • Registrat/da: 22 / Des / 2009
  • Darrera visita: 04 / Oct / 2011
  • Enviaments: 40

  Enviat: 11/Maig/2010 - 16:58

  Hola;
  Tinc per aqui una altre amiga wifi que no li dona la gana de treballar;
  us la presento:
  
  # hwinfo --netcard
  ..
  35: PCI 405.0: 0282 WLAN controller
  [Created at pci.318]
  UDI: /org/freedesktop/Hal/devices/pci_14e4_4318
  Unique ID: y9sn.U4rP_nCgBW9
  Parent ID: 37TO._XJP+gD25h8
  SysFS ID: /devices/pci0000:00/0000:00:10.0/0000:04:05.0
  SysFS BusID: 0000:04:05.0
  Hardware Class: network
  Model: "AMBIT Microsystem TravelMate 2410"
  Vendor: pci 0x14e4 "Broadcom"
  Device: pci 0x4318 "BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller"
  SubVendor: pci 0x1468 "AMBIT Microsystem Corp."
  SubDevice: pci 0x0312 "TravelMate 2410"
  Revision: 0x02
  Driver: "b43-pci-bridge"
  Driver Modules: "ssb"
  Device File: wlan0
  Features: WLAN
  Memory Range: 0xc3000000-0xc3001fff (rw,non-prefetchable)
  IRQ: 18 (no events)
  HW Address: 00:16:cf:ac:e1:c2
  WLAN channels: 1 2 3 4 5 6 7 8 9 10 11
  WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462
  WLAN encryption modes: WEP40 WEP104 TKIP CCMP
  WLAN authentication modes: open sharedkey wpa-psk wpa-eap
  Module Alias: "pci:v000014E4d00004318sv00001468sd00000312bc02sc80i00"
  Driver Info #0:
  Driver Status: ssb is active
  Driver Activation Cmd: "modprobe ssb"
  Config Status: cfg=no, avail=yes, need=no, active=unknown
  Attached to: #28 (PCI bridge)
  ..
  
  Kernl: 2.6.27.29-0.1-pae
  Actualitzacions al dia
  
  
  Un d'aquests portàtils (Aspire 7000) veu la wlan0 ja que diguem "s'encen" la llumeta
  tot engegar l'aparell, per tant ens surt a l'output de ifconfig -a; pero a l'altre ni això.
  
  Es a dir, double trouble!
  
  Cap suggerència per implementar sobre aquests dos misteris..
  Gràcies!
  
  cQTechAdminSolutions

  • 
  •  
• cqtechasol
  

  • Registrat/da: 22 / Des / 2009
  • Darrera visita: 04 / Oct / 2011
  • Enviaments: 40

  Enviat: 11/Maig/2010 - 17:03

  En el que SI s'aixeca el device en iniciar;
  ## Output referent a wlan0 desprès de reniciar el network manager
  May 11 16:59:44 batx33 NetworkManager: <info> (wlan0): now unmanaged
  May 11 16:59:44 batx33 NetworkManager: <info> (wlan0): device state change: 3 -> 1
  May 11 16:59:44 batx33 NetworkManager: <info> disconnected by the system bus.
  May 11 16:59:46 batx33 NetworkManager: <info> starting...
  May 11 16:59:46 batx33 NetworkManager: <info> modem-manager is now available
  May 11 16:59:46 batx33 NetworkManager: <WARN> nm_generic_enable_loopback(): error -17 returned from rtnl_addr_add(): Sucess
  May 11 16:59:46 batx33 NetworkManager: <info> eth0: driver is 'forcedeth'.
  May 11 16:59:46 batx33 NetworkManager: <info> Found new Ethernet device 'eth0'.
  May 11 16:59:46 batx33 NetworkManager: <info> (eth0): exported as /org/freedesktop/Hal/devices/net_00_16_d3_4d_2e_85
  May 11 16:59:46 batx33 NetworkManager: <info> wlan0: driver is 'b43-pci-bridge'.
  May 11 16:59:46 batx33 NetworkManager: <info> wlan0: driver supports SSID scans (scan_capa 0x01).
  May 11 16:59:46 batx33 NetworkManager: <info> Found new 802.11 WiFi device 'wlan0'.
  May 11 16:59:46 batx33 NetworkManager: <info> (wlan0): exported as /org/freedesktop/Hal/devices/net_00_16_cf_ac_e1_c2
  May 11 16:59:50 batx33 NetworkManager: <info> (eth0): device state change: 1 -> 2
  May 11 16:59:50 batx33 NetworkManager: <info> (eth0): bringing up device.
  May 11 16:59:50 batx33 NetworkManager: <info> (eth0): preparing device.
  May 11 16:59:50 batx33 NetworkManager: <info> (eth0): deactivating device (reason: 2).
  May 11 16:59:50 batx33 NetworkManager: <info> (eth0): carrier now ON (device state 2)
  May 11 16:59:50 batx33 NetworkManager: <info> (eth0): device state change: 2 -> 3
  May 11 16:59:50 batx33 NetworkManager: <info> (wlan0): device state change: 1 -> 2
  May 11 16:59:50 batx33 NetworkManager: <info> (wlan0): bringing up device.
  May 11 16:59:50 batx33 NetworkManager: <WARN> nm_device_hw_bring_up(): (wlan0): device not up after timeout!
  
  What is reason 2?
  May 11 16:59:50 batx33 NetworkManager: <info> (wlan0): deactivating device (reason: 2).
  
  cQTechAdminSolutions

  • 
  •  
• jgraci25
  
  

  • Rang:
  • Registrat/da: 31 / Mar / 2023
  • Darrera visita: 27 / Feb / 2023
  • Enviaments: 2380

  Enviat: 12/Maig/2010 - 00:13

  Hola,
  
  A:
  
  http://forums.opensuse.org/get-help-here/wireless/387778-suse-11-wifi-bcm4318.html
  
  
  Hi trobaràs la solució.
  
  
  En resum, s'ha de fer servir una eina que té Linkat/opensuse11.1 que permet descarregar el firmware de la placa wifi. La utilitat és la install_bcm43xx_firmware que es troba dins del paquet (que hauràs d'instal·lar segurament) bcm43xx-fwcutter
  
  Així doncs, i fent un resum:
  
  
  zypper in bcm43xx-fwcutter
  /usr/sbin/install_bcm43xx_firmware
  
  
  Joan de Gracia

  • 
  •  
• pablo.vigo
  
  

  • Rang:
  • Registrat/da: 23 / Mar / 2006
  • Darrera visita: 14 / Jun / 2019
  • Enviaments: 4529

  Enviat: 12/Maig/2010 - 17:02

  El paquet es diu "b43-fwcutter"
  
  Salut.
  
  Projecte Linkat

  • 
  •  
• cqtechasol
  

  • Registrat/da: 22 / Des / 2009
  • Darrera visita: 04 / Oct / 2011
  • Enviaments: 40

  Enviat: 18/Maig/2010 - 15:25

  Aquí heu estat implacables. Funciona
  
  cQTechAdminSolutions

  • 
  •  
•  
•  

Usuaris connectats

• 0 usuaris

Aquesta llista mostra els usuaris actius durant els darrers 20 minuts.